Amp research power step installation1/23/2024 The passenger side harness is routed along the firewall to that side. The control module mounts under the hood of our Ram and to the wire harness with some tie straps.Īfter removing the inline fuse, hook the red to the positive battery terminal and the ground to the body ground. There is some flexibility to move the step forward or backward as needed. The steps have sliding brackets on the underside that bolt to the Power Step linkages. This is one of the driver side linkages installed and ready for the step. The linkages are installed in the mounting plates then the two bolts are tightened up. Two for each side - one with a motor and one without. Insert two steel pop rivets in each bracket and then tighten the allen set screw at the bottom of the bracket. The mounting insert slides through the sill hole then the bolt will pull the insert up tight, holding the bracket flush against the sidewall.ĭrill the body through the predrilled holes in the brackets using your right angle drill. There are two of these for each side of the truck. The motor bolts even had Lok-tite pre-applied. The motors need unpackaged and bolted to the linkage assembly.Īmp Research pays an incredible amount of attention to packaging and detail. The Dodge Mega Cab install requires you remove the sill tape from the 3rd and 8th opening from the front. It will save a stop to wash the dirt out of your eyes. It would be advisable that you wash the under side of your truck before you start the install. Note that you will need a right angle drill or converter and a pop rivet tool Some of the tools we would need for the install of the Power Steps. The small box is the Bed Step which we will install in a later article. Our new Power Steps just arrived via UPS. The AMP Research Power Step is virtually hidden from view and fully protected when it is retracted. Traveling over a bump, ridge, or off camber section with a long wheelbase vehicle puts the center of your truck much lower to the obstacle than with a short wheelbase vehicle. And the longer your wheelbase, the more you need these Power Steps. You do not want steps and running boards hanging down where they can get ripped off anytime you take it slightly off the highway. This is especially important on any 4x4 or off-road truck. These steps make it easy to get in and out of your Dodge Ram yet they fully retract when the door is closed. The Dodge Ram is the perfect candidate for the AMP Research Power Step. And that is before larger tires or a suspension lift. The 2007 Dodge Ram sits much higher than the Chevy or GMC trucks right from the factory, which means a higher step and entry point. We begin Project MegaRam with installation of AMP Research Power Steps.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |